THOMSON CARBON CYCLOCROSS BAR 42cm

CBS Part Number: HB3010

More Views

THOMSON CARBON CYCLOCROSS BAR 42cm
CBS Part Number: HB3010
Brand: Thomson
UPC: 875850006218
Vendor Part No: HB-E111

Availability: In stock

Warehouse East: OUT OF STOCK

Warehouse West: 5 AVAILABLE

The KFC-One, Katie Compton Signature ¥cross bar. Katie brings her multiple National Championships and European racing experience to give you a bar built her way for cross. Twin flats on the bottom of the bar allow taping your housing to create a completely round bar when wrapped. Top profile is round and as wide as possible. This allows auxiliary brake levers to be safely used and still leaves lots of room for your hands. Certified to EN, tested to DIN+. Layup uses 3 different fiber types with different tensile strengths and tensile modulus, including High Strength carbon fiber. This helps allocate stiffness and flex where needed. Made in one piece, not three pieces co-molded and glued together and are molded over an EPS mandrel to avoid wrinkles inside the layup during molding. Most other bars are molded over inflatable nylon bladders. 1.5K woven impact ends help prevent damage to uni-directional fibers from impact. 200g (40cm center to center).
Details

Details

Carbon Cross:~ The KFC-One, Katie Compton Signature ¥cross bar. Katie brings her multiple National Championships and European racing experience to give you a bar built her way for cross. Twin flats on the bottom of the bar allow taping your housing to create a completely round bar when wrapped. Top profile is round and as wide as possible. This allows auxiliary brake levers to be safely used and still leaves lots of room for your hands. Certified to EN, tested to DIN+. Layup uses 3 different fiber types with different tensile strengths and tensile modulus, including High Strength carbon fiber. This helps allocate stiffness and flex where needed. Made in one piece, not three pieces co-molded and glued together and are molded over an EPS mandrel to avoid wrinkles inside the layup during molding. Most other bars are molded over inflatable nylon bladders. 1.5K woven impact ends help prevent damage to uni-directional fibers from impact. 200g (40cm center to center).
  • • Bars measured center to center. 1.5K woven impact ends help prevent damage to uni-directional fibers from impact.
  • • Bars are molded over an EPS mandrel to avoid wrinkles inside the layup during molding. Most other bars are molded over inflatable nylon bladders.
  • • Bars are made in one piece, not three pieces co-molded and glued together.
  • • Layup uses 3 different fiber types with different tensile strengths and tensile modulus, including High Strength carbon fiber. This helps allocate stiffness and flex where needed.
  • • Certified to EN, tested to DIN+. 200g (40cm)